Bosch CTL636ES6 User Manual

ImportAppliances.com
THE EASIEST WAY TO SELF-IMPORT APPLIANCES DIRECT FROM EUROPE.
47
en
Menu
F
It is important to set the water hard-
ness correctly to enable the appli-
ance to accurately indicate when the
descaling programme should be run�
You can check the water hardness using
the enclosed test strip or by asking your
local water supplier� If a water softening
system is installed in the house, please
select the “Softening device” setting�
Water filter
If a water lter is inserted, renewed or
removed, the setting “insert”, “replace” or
“remove” must be made in the menu�
F
A water filter lessens limescale
deposits, reduces impurities in water
and improves the coffee taste�
Water lters are available from retail
outlets or from customer services
(see the section “Accessories”)�
Inserting or renewing a water lter:
A new water lter must be rinsed before it
can be used�
■ Turn the control ring to select either
“insert” or “replace”�
■ Press the water lter rmly into the
opening of the water tank�
■ Fill the water tank with water up to the
“max” mark�
■ Remove the milk tube from the milk
container and close the door�
F
Caution: Do not jam the tube when
closing the door�
■ Place a container with a capacity of
0�5 litre under the outlet �
■ Press C�
Water will now ow through the lter to
rinse it�
■ Then empty the container�
The appliance is ready for use again�
F
Rinsing the filter simultaneously
activates the setting for the change
filter display�
The lter is no longer e󰀨ective when the
“Replace water filter– Press A” display
appears, or at the latest after two months� It
needs to be replaced for reasons of hygiene
and to prevent a build-up of limescale
(which could damage the appliance)�
■ If a new lter is not inserted, select the
setting [ remove ] and press C�
The message “Remove filter, reinsert
watertank, close door” appears�
F
If the appliance has not been used
for a prolonged period (for example,
while you are on holiday), the exist-
ing filter should be rinsed before the
first time the appliance is used again�
To do this, simply dispense a cup of
hot water�
Detailed information about the water lter
can be found in the manual supplied with
the lter.
Home Connect
Settings for connection to WLAN network
(home network) and mobile devices (see
section “Home Connect”)�
Switch off after
To set how long the appliance should wait
after the last drink was prepared before it
automatically rinses and switches itself o󰀨.
You can specify values from 15 minutes to
8 hours� The factory setting is 30 minutes�
Illumination
Setting the illumination of the beverage
outlet� “on”, “when in use” or “off” can be
selected�
Brightness illumination
Setting the illumination lightness of the
beverage outlet� “Level 1” to “Level 10” can
be selected�
Brightness display
Setting the illumination lightness of display�
Key tones
Switch the signal tones on or o󰀨.

Bosch CTL636ES6 Specifications

General

Product type	Espresso machine
Built-in grinder	Yes
Capacity in cups	- cups
Milk adding type	Automatic
Number of spouts	1
Coffee input type	Coffee beans
Coffee maker type	Fully-auto
Appliance placement	Built-in
Water tank capacity	2.4 L
Coffee beans capacity	500 g
Maximum operating pressure	19 bar
Reservoir for brewed coffee	-
Cord length	1.7 m
Display type	TFT
Product color	Black, Stainless steel
AC input voltage	220–240 V
AC input frequency	50 - 60 Hz
Package depth	670 mm
Package width	475 mm
Package height	545 mm
Package weight	22420 g

Weight and Dimensions

Depth	375 mm
Width	594 mm
Height	455 mm
Weight	19440 g
Installation compartment depth	356 mm
Installation compartment width	558 mm
Installation compartment height	449 mm