Bosch D7024 - Page 49

D7024 | Operation and Installation Guide | 7.0 Control Panel Programming
Bosch | 7/05 | 31499J 49
The following window appears:
1. Press the number key corresponding to the
telephone number you want to configure, such as
Phone #1. The following window appears:
2. Press the number key corresponding to your
selection.
Refer to the following sub-sections (Number,
Format, Account Numbers, and Tone) for telephone
number option descriptions.
Number
The display scrolls through the Phone Number options.
1. Press [1] for NUMBER and to access:
2. Press [SILENCE] to ignore the wait for dial tone
character.
3. Enter the telephone number and press [#]. The
preceding menu appears.
Several special control characters can be included in the
telephone number by pressing [TEST] and a digit:
Ta b l e 2 7 identifies keys that assist when entering
telephone numbers.
If the Wait for Dial Tone is not specified, the control
panel waits 7 sec after going off-hook and then dials,
whether or not the dial tone is present.
Format
Shortcut:
0-PROG > 6-PROG ACC'NTS >1-PHONE NUMS
This feature allows you to select which communication
format to use. It also allows you to disable
communication for the telephone number. To disable
the dialer, set the format for Phone Lines 1 and 2 to
“disabled” and turn off the monitoring feature of both
lines.
The display scrolls through the Phone Number options.
1. Press [2] for FORMAT to access:
2. Press the number key corresponding to your
selection.
The preceding window appears.
Table 26: Telephone Number Control Characters
Press See Do
[TEST] 1 * Touch Tone “*”
[TEST] 2 # Touch Tone “#”
TEST] 3 / 3-sec delay
[TEST] 4 > Wait for dial tone
PHONE NUMBER
1- PHONE #1
2- PHONE #2
3- COMPTR PHONE
PHONE NUMBER #1
1- NUMBER
2- FORMAT
3- ACCT NUMS
4- TONE
PHN NMBR 1: ????
>???????????????
Table 27: Telephone Number Assistance Keys
Press Action
[SILENCE] Advance to next position.
[DISABLE] Go back one position.
[RESET] Clear position.
Except for unusual situations, begin all tele-
phone numbers with the Wait for Dial Tone
character. This ensures the reports are deliv-
ered as quickly as possible even if an incom-
ing telephone call must be disconnected.
PHONE FORMAT (_ _)
0- DISABLE
1- 3/1 REPORT
2- 4/2 REPORT
3- BFSK REPORT
4- SIA, 110 RPT
5- CONTACT ID
6- SIA, 300 RPT
7- MDM 3A2