9
Turn the Entire System On With Delays
❒ I have this feature.
❒ I do not have this feature.
❒ This feature requires a passcode.
COMMAND 1 is used to arm the entire system, both perimeter and
interior points. Once you have entered COMMAND 1, the exit delay time
starts. You now have a predetermined amount of time to exit the
protected area before the system arms. During the exit period, you can
move through motion detectors or any protected area on your way to any
exit without causing an alarm. To cancel COMMAND 1, enter your
personal passcode and press ENT.
Note: If you leave the building after the exit time expires, you may begin
the entry delay, or initiate an alarm. It this happens, disarm your system
by entering your personal passcode and press ENT. It your system
reports to a Central Station, you need to call them if an alarm occurs.
Application
COMMAND 1 is useful in applications where you want your cleaning
service, a service person, or anyone else to arm your system when they
leave, but you do not want them to have the passcode to disarm the
system. COMMAND 1 arms the system, but it will not disarm the system.
COMMAND 1
Arming with COMMAND 1:
1. Ensure that all points are secure. All of the Point Status indicator lights
on the Command Center should be off. If they’re not, see the section
describing Force Arming the System.
2. Press the COMMAND bar. The Command Mode indicator light comes
on.
3. Press the 1 key. The PERIMETER indicator and the INTERIOR
indicator lights begin to flash on and off. This indicates that the system
has begun exit delay time.
4. To disarm your security system or cancel COMMAND 1, enter your
personal passcode and press ENT before the delay time expires.
To Next Page
Loading...
