Bosch D1260 User Manual

Command Center D1260
Owner’s Manual
This system includes a telephone line seizure feature. The system may be programmed to communicate with a central
monitoring station to report system events. You will not be able to use your phone while the system is communicating
with the central monitoring station. In the unlikely event that the central station is not able to receive the report, your
phone may be unavailable for up to 20 minutes while the panel makes additional communication attempts.
National Security Systems Inc (800)457-1999

Bosch D1260 Specifications

General

Type	Alphanumeric Keypad
Backlight	Yes
Housing Material	ABS plastic
Communication	RS-485
Operating Voltage	12 VDC
Compatibility	Bosch Control Panels
Display	LCD
Power	From control panel

Summary

Part I: Security System Basics

Using the Command Center

Command Center Keys

Points

View Faulted or Bypassed Points

Guides users on how to check for and identify faulted or bypassed points.

Warning Displays and Tones

Fire Alarms

Details how fire alarms are indicated, silenced, and managed.

Burglary Alarms

Explains the process for silencing and managing burglary alarms.

Silencing an Alarm

Explains how to silence an active alarm using a passcode.

Part II: System Commands

Entering a Passcode

Guides users on how to enter their passcode for system operations.

Turning the System On (Arming)

Explains how to arm the security system using various methods.

Turning the System Off (Disarming)

Details the process for disarming the security system.

Turning On the System (Arming) With Doors or Windows Open

Explains how to arm the system when points are faulted (open doors/windows).

MASTER ARM ? (COMMAND + 1)

Details the command to arm the entire system, including perimeter and interior.

WALK TEST ? (COMMAND + 4 + 4)

Guides on performing a walk test of system components.

RESET SENSORS ? (COMMAND + 4 + 7)

How to reset activated sensors like smoke detectors.

Part III: Advanced Commands

Advanced Commands

BYPASS A POINT? (COMMAND + 0)

How to temporarily disable specific points from detection.

UNBYPASS A POINT? (COMMAND + 0 + 0)

How to re-enable previously bypassed points.

DEL USER ? (COMMAND + 5 + 3)

How to delete a user and their associated data from the system.

CHG PASSCODES ? (COMMAND + 5 + 5)

How to change user passcodes without security company assistance.

ADD/CHANGE USER (COMMAND + 5 + 6)

How to add or modify user information and settings.

FIRE TEST ? (COMMAND + 5 + 8)

How to test fire points and other 24-hour points.

Part IV: Multi-Area Use

Working with Multiple Areas from a Single Command Center

Turning On the System

How to arm the system, including selected areas or all areas.

Turn On the Entire System Without Delays

Turning Off the System

How to disarm the system, including selected areas or all areas.

Turning Off Selected Areas