Part III: Advanced Commands
DOOR CONTROL (COMMAND + 4 + 6)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
DOOR CONTROL (COMMAND + 4 + 6)
Description
There are three functions with the door control function:
• Cycle Door – momentarily unlocks a door to allow a person into an area
• Unlock Door – unlocks a door to allow free access
• Secure Door – locks a door and prohibits access regardless of a user’s authority level
Using Door Control
1. Ensure your command center shows idle disarmed
text.
2.
Press the COMMAND key.
3. The display shows *System Command*.
4. Press the 4 key and the 6 key.
+
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the DOOR CONTROL ?> prompt then press the
adjacent soft key.
5. The display will change and show a choice of Cycle
Door>, Unlock Door>, and Secure Door>.
Press the adjacent soft key.
To Next Page
Loading...
