EasyManua.ls Logo

Bosch D1260 - Table of Contents

Bosch D1260
154 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Contents
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
Note: Some commands listed below may not be available. Contact your security company for more information.
Introduction
Your Command Center
About This Owner’s Manual
Part I: Security System Basics
Using the Command Center
Command Center Keys
Points
Your Custom Display
View Faulted or Bypassed Points
Warning Displays and Tones
Fire Alarms
Burglary Alarms
Fire Trouble and Fire Supervisory Events
Non-Fire Trouble and Supervisory Events
Special System Trouble Display
Silencing an Alarm
Part II: System Commands
Entering a Passcode
Turning the System On (Arming)
Turning the System Off (Disarming)
Turning the System On (Arming) With a Duress
Passcode
Turning the System On (Arming) With Doors or
Windows Open
MASTER ARM ? (COMMAND + 1)
MASTER ARM INST ? (COMMAND + 1 + 1)
PERIMETR INST (COMMAND + 2)
PERIMETR DELAY ? (COMMAND + 3)
Silence the Trouble Sounder & Clear Trouble Display
(COMMAND + 4)
VIEW MEMORY ? (COMMAND + 4 + 0)
WALK TEST ? (COMMAND + 4 + 4)
RESET SENSORS ? (COMMAND + 4 + 7)
WATCH MODE ? (COMMAND + 6)
PERIMETR PART ? (COMMAND + 8)
Special Alerts (COMMAND + 7 and COMMAND + 9)
Part III: Advanced Commands
Advanced Commands
Terms Used in This Section
BYPASS A POINT? (COMMAND + 0)
UNBYPASS A POINT? (COMMAND + 0 + 0)
SEND REPORT ? (COMMAND + 4 + 1 or
COMMAND + 4 + 2)
REMOTE PROGRAM ? (COMMAND + 4 + 3)
CHANGE TIME/DATE (COMMAND + 4 + 5)
DOOR CONTROL (COMMAND + 4 + 6)
Access Level
CHANGE DISPLAY (COMMAND + 4 + 9)
EXTEND CLOSING (COMMAND + 5 + 1)
CHG SKEDS ? (COMMAND + 5 + 2)
DEL USER ? (COMMAND + 5 + 3)
CHG RELAYS ? (COMMAND + 5 + 4)
CHG PASSCODES ? (COMMAND + 5 + 5)
ADD/CHANGE USER (COMMAND + 5 + 6)
DEFAULT TEXT ? (COMMAND + 5 + 7)
FIRE TEST ? (COMMAND + 5 + 8)
DISPLAY REV ? (COMMAND + 5 + 9)
SERVICE MENU ? (9 + 9 + Enter)
Part IV: Multi-Area Use
Working with Multiple Areas from a Single Command
Center
View Area Status
View Point Status
MOVE TO AREA ? (COMMAND + 5 + 0)
Turning the System On
Turn the Entire System On Without Delays
Turning the System Off
Appendix
Supplementary Information for Adding Passcodes
User Authority Levels
Passcode Worksheet
Security System Limitations
Fire Safety and Evacuation
Standard Displays
System Trouble Displays
Security System Glossary
Maintenance and Service
How to Clean the Command Center
Your Alarm Company

Table of Contents

Other manuals for Bosch D1260

Related product manuals