Part II: System Commands
MASTER ARM INST ? (COMMAND + 1 + 1)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
MASTER ARM INST ? (COMMAND + 1 + 1)
Use this function to turn on a single area, both perimeter and interior without delays. When entering COMMAND 11,
remember that the second 1 must be pressed within 2 seconds after pressing the first 1.
The menu entry MASTER ARM INST> is different in that it allows all or selected areas to be armed instantly.
Note: COMMAND 11 does not comply with SIA CP-01 Standard.
Note: Using the COMMAND + 1 + 1 shortcut will only instantly arm the area where the keypad has been assigned.
Example, if the D1260 is assigned to Area 1, only Area 1 will be armed when COMMAND + 1 + 1 is pressed.
1. The display shows disarmed idle text.
2.
Press the COMMAND key. The display shows *System
Command*.
3.
Press the 1 key. Now press the 1 key again.
+
4. The command center display shows AREA 1
WAREHOUSE All On Instant.
5. To disarm your security system, enter your personal
passcode and press ENTER.
To Next Page
Loading...
