Part III: Advanced Commands
Access Level
D1260 Owner’s Manual
50410C © 2003 Bosch Security Systems
Access Level
This function is used to manually enable/disable access authority levels assigned to users. It can also be used to
temporarily disable a user’s access level instead of deleting and then re-adding the user.
I have this feature.
I do not have this feature.
1. Ensure your command center shows idle disarmed
text.
2. Press the Menu> soft key to enter the Command
Menu,
then press Next> soft key repeatedly
until you reach the CHANGE LEVEL ?> prompt then
press the adjacent soft key.
3. A prompt will appear asking for entry of the Authority
Level to be modified.
Enter the level number (1 – 14) and press the Enter>
soft key.
4.
If the level entered is currently enabled, the command
center will ask if you want to disable this level.
(Level 14 is used here as an example.)
5. If the level entered is currently disabled, the command
center will ask if you want to enable this level.
(Level 14 is used here as an example.)
6. After selecting whether to disable or enable the level,
the display prompts you again to enter an Authority
Level to modify.
7. Press the <Exit soft key when you are finished.
To Next Page
Loading...
