Part III: Advanced Commands
SEND REPORT ? (COMMAND + 4 + 1 or COMMAND + 4 + 2)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
SEND REPORT ? (COMMAND + 4 + 1 or COMMAND + 4 + 2)
Description
This function tests the communication link between your security system and your security company. It is an important
part of maintaining a high level of security for your property.
Two types of test reports may be sent. The first type of report is a simple test report (Command 41). The second type of
report is a status report (Command 42). This status report indicates the current condition of your system.
Using Send Report
1. Always call your security company before sending a test report.
2. Ensure your command center shows idle disarmed
text.
3.
Press the COMMAND key.
4. The display shows *System Command*.
5.
Press the 4 key then the 1 key to send a test report.
Press the 4 key then the 2 key to send a status report.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the SEND REPORT ?> prompt then press the
adjacent soft key.
Another menu appears allowing for the selection of sending a test
report (Test Rpt?>) or a status report (Status Rpt?>). Press either
one of the adjacent soft keys.
6. The command center displays Sending report… Please
wait… until the report is transmitted to the security
company.
7. When the transmission is complete the command
center displays Report sent for 5 seconds.
Note: If the <Exit soft key is pressed before 5 seconds
have elapsed, idle text will be displayed.
To Next Page
Loading...
