Part III: Advanced Commands
ADD/CHANGE USER (COMMAND + 5 + 6)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
ADD/CHANGE USER (COMMAND + 5 + 6)
Use this function to add or change a user to your system without assistance from your security company. You need to
know which user numbers are available, the authority level you want to assign to the new passcode and the areas in which
it will be valid before you add it.
The user numbers identify users in reports transmitted from your system. Additionally, you will be able to change the
following:
• the authority level (which determines what system functions the passcode can access)
• the area number (which identifies which parts of your security system the user will have access to)
• the name of the user
• the card number they use for access control
• whether they are a Master or Sub-User.
Contact your security company if you don’t know what user numbers, authority levels, or areas are available. See the
Appendix for further information on adding passcodes.
Before you begin, keep these points in mind:
• Do not try to add new users without knowing the available user numbers. An already defined user number
will be overwritten when the new user is defined. These are two or three digit numbers, not to be confused
with passcodes, that identify users at your security company.
• When choosing passcodes, choose a new passcode three to six digits long. If you choose a passcode with the
same digit in consecutive order (for example “33” in 334697), take care when entering it.
• To avoid conflicting with other passcodes and duress codes, your system does not let you change passcodes
that are the same within plus or minus 2 of an existing passcode. For example, if 1234 were an existing code,
your system would not let you add or change your code to 1232, 1233, 1234, 1235, or 1236.
• Choose an authority level for each area. Not assigning the authority level for an area denies the passcode
access to that area.
1. Ensure your command center shows idle disarmed
text.
2.
Press the COMMAND key.
3. The display shows *System Command*.
4.
Press the 5 key and then the 6 key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft repeatedly
until you reach the ADD/CHG USER ?> prompt then press the
adjacent soft key.
To Next Page
Loading...
