Part III: Advanced Commands
DISPLAY REV ? (COMMAND + 5 + 9)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
DISPLAY REV ? (COMMAND + 5 + 9)
1. Ensure your command center shows idle disarmed
text.
2.
Press the COMMAND key.
3. The display shows *SYSTEM COMMAND*.
4.
Press the 5 key and then the 9 key.
+
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> key to enter the Command Menu,
then press Next> repeatedly
until you reach the DISPLAY REV ?> prompt then press the
adjacent soft key.
5. The display will change to Radionics D9412* Version
6-40
(D9412 and 6-40 are used as an example, other panels
could be D9112, D7412, D7212)
6. The display will return to idle text after 5 seconds.
To Next Page
Loading...
