Part III: Advanced Commands
SERVICE MENU ? (9 + 9 + Enter)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
SERVICE MENU ? (9 + 9 + Enter)
The service menu is used to access the following commands:
• View Log - Use this function to review events in your system at your command center. Reviewing past
events may help you identify problems. Viewing events does not require any additional equipment since the
information is displayed at your command center. Events are stored in the panel’s memory in order of
occurrence and tagged with the date and time.
• Print Log - The Print Log function lets you print the events stored in your security system’s log. You can
choose to print the entire log or set a start date and print the events recorded from that date up to today.
Your system must include a parallel printer interface and a printer to perform this function.
• Display Rev (COMMAND + 5 + 9) - The command will retrieve the panel’s software version and display it.
• Service Walk (D9412/D9112 only) – The command will allow all the points on the system to be walk tested
regardless of the type of point. For D7412 and D7212 panels this function must be added to the keypad’s
menu. Contact your security company for more information.
• Default Text – This command will show the current state of the area for 3 seconds before returning to idle
text.
1. Ensure your command center shows idle disarmed
text.
2.
Press the 9 key twice.
+
3.
Press the ENTER key.
4. The display changes to
show the service menu.
Pressing the Next> soft
key displays more
options.
Service Walk Test?> appears on
D9412/D9112 Panels only
Using View Log
1. Press the View Log ?> soft key.
2. The display changes to Enter start date:
Press the Go to last event> soft key to go to the last
event in the log.
Press the <Exit soft key to exit this function and return
to idle text.
3. Enter the start date in the form of mm/dd.
Ex: To enter 7/14 as the start date, press 0 + 7 + 1
+ 4
Once you start entering digits, the Go to last event>
soft key is replaced with the Enter> soft key.
Press the <Exit soft key to exit this function and return
to idle text.
To Next Page
Loading...
