Part III: Advanced Commands
CHANGE TIME/DATE (COMMAND + 4 + 5)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
CHANGE TIME/DATE (COMMAND + 4 + 5)
The time and date in your system must be correct for scheduled events to occur at the correct times. Check the time at
least once a month to ensure accuracy. Use this function to set both the time and date. The system uses a 12-hour,
AM/PM format. There is the option to continuously display the time and date in place of area status. The Time and Date
will be shown continuously until a new command is entered or the current area’s status has changed. See CHANGE
DISPLAY (COMMAND + 4 + 9), Time/Date Display for more information.
1.
Ensure your command center shows idle disarmed
text.
2.
Press the COMMAND key.
The display shows *System Command*.
3.
Press the 4 and then the 5 key.
+
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the CHG TIME/DATE ?> prompt then press the
adjacent soft key.
4. The display changes to Enter new time:
To just change the date, press the Set Date> soft key,
See Step 6.
If you input the wrong time, press the <Exit soft key to
clear the time.
Enter the new time using a 12-hour (HH:MM) format.
Ex: If the desired time is 12:34, press 1 + 2 + 3 + 4
Note: The Set Date> soft key will disappear when
the first digit is entered.
Press the Enter> soft key or the [ENTER] button.
The display changes to show AM> or PM> soft keys.
Press the AM> soft key to
select AM.
5.
Press the PM> soft key to
select PM.
To Next Page
Loading...
