Part III: Advanced Commands
CHG PASSCODES ? (COMMAND + 5 + 5)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
CHG PASSCODES ? (COMMAND + 5 + 5)
Description
Use this function to change your personal passcode without assistance from the security company.
Before you begin:
• Choose a new passcode three to six digits long. If you choose a passcode with the same digit in consecutive
order (for example “33” in 334697), take care when entering it.
• To avoid conflicting with other passcodes and duress codes, your system does not let you change passcodes
to an existing passcode or to within plus or minus 2 of an existing passcode. For example, if 1234 were an
existing code, your system would not let you change your code to 1232, 1233, 1234, 1235, or 1236.
Using Chg Passcodes
1. Ensure your command center shows idle disarmed
text.
2.
Press the COMMAND key.
3. The display shows *System Command*.
4.
Press the 5 key and then the 5 key.
+
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft repeatedly
until you reach the CHG PASSCODES ?> prompt then press the
adjacent soft key.
5. You will prompted for your passcode.
As soon as a number is pressed, Entering: appears on
the third line next to the asterisks.
The passcode is shown as asterisks (*) when entered
and advance from the right side of the display to the
left until all passcode digits are entered.
6. The display changes to Enter new passcode:
Enter the new passcode.
As soon as a number is pressed, Entering: appears on
the third line next to the asterisks.
The passcode is shown as asterisks (*) when entered and advance from the right side of the display
to the left until all passcode digits are entered.
To Next Page
Loading...
