Bosch D1260 - DEL USER? (COMMAND + 5 + 3)

Part III: Advanced Commands
DEL USER ? (COMMAND + 5 + 3)
D1260 Owner’s Manual
© 2003 Bosch Security Systems 50410C
DEL USER ? (COMMAND + 5 + 3)
This function allows a user to be deleted.
Note: This function will delete the passcode, Master User, and all sub-users associated with the user number.
1. Ensure your command center shows idle disarmed
text.
2.
Press the COMMAND key.
3. The display shows *System Command*.
4.
Press the 5 key and then the 3 key.
Note: If you prefer, you may use the Command Menu in place of steps 2 and 3 to initiate this function.
Press the Menu> soft key to enter the Command Menu,
then press Next> soft key repeatedly
until you reach the DEL USER ?> prompt then press the adjacent
soft key.
5. The display changes to show Enter user # to be deleted:
Enter the user number, not the passcode. (123 is as an
example.)
Press either the Enter> soft key or the ENTER button.
6. If the user number entered is a valid user in the
system, the display will show Delete User 123? Are you
sure?
(123 is as an example.)
If the user number entered is not a valid user in the
system, the display will show This user is currently not
in use.