15
Enable Remote Account Management
❒ I have this feature.
❒ I do not have this feature.
❒ This feature requires a passcode.
Your security system has the ability to be managed remotely from your
security company without having a service person on the protected
premises. By using COMMAND 4 3, you can enable remote account
management. Remote account management is done with the aid of a
specially equipped computer at your security company.
Typical remote programming changes may include: adding or deleting
system commands, and changing personal passcodes or entry/exit delay
times.
COMMAND 4 3
To use COMMAND 4 3:
1. Your system may be either armed or disarmed to perform this function.
2. Call your security company using this phone number:
_________________________________________________________
This number is designated for the Remote Account Manager. You must
make the call using the telephone located:
_________________________________________________________
3. Identify yourself and your premises (account number, name, address,
etc.) and advise the operator of the programming changes you wish to
have performed.
4. When the operator directs you, enter COMMAND 4 3 at your Com-
mand Center:
Press the COMMAND bar. The Command Mode indicator light comes
on.
5. Press the 4 key, and then press the 3 key. The telephone line that the
call was made from is not active when remote account management is
in progress. You may hang up the telephone.
6. When remote account management has been completed, your
telephone line will automatically restore normal service.
To Next Page
Loading...
