14
Send Report
❒ I have this feature as Command 41.
❒ I have this feature as Command 42.
❒ I do not have this feature.
❒ This feature requires a passcode.
This function tests the communication link between your security system
and your security company. It is an important part of maintaining a high
level of security for your property.
Two types of test reports may be sent. The first type (Command 41)
simply tests the communication of security messages to your security
company. The second type is a status report (Command 42). This status
report sends the current condition of your system in addition to testing the
communication link to your security company.
COMMAND 4 1 & 4 2
To use COMMAND 4 1 or COMMAND 4 2:
1. Always call your security company before sending a test report.
2. Ensure that your security system is disarmed.
3. Press the COMMAND bar. The Command Mode indicator light comes
on.
4. Press the 4 key, and then press the 1 key, or press the 4 key and then
the 2 key for COMMAND 42.
5. After the report is received at your security company, the Command
Center will emit a beep tone for two seconds. This is to confirm that the
test signal was properly transmitted and received.
To Next Page
Loading...
