7
Silencing an Alarm
The audible alarm sounds for a specific period of time before it automati-
cally shuts off. If an alarm occurs and you want to silence the bell or siren
before the time expires, simply enter your personal passcode and press
ENT.
After silencing the alarm and returning points to normal, you can clear the
alarm memory lights by entering your passcode twice (arm and disarm).
On some systems the alarm memory lights can be cleared by entering
COMMAND 4.
To SILENCE an alarm:
• Enter your personal passcode and press ENT.
Note: Some security systems are programmed so that bells or sirens
cannot be silenced until the point is restored to a normal (non-alarm)
condition.
Reporting to the Central Station
❒ My system reports to a Central Station.
❒ My system does not report to a Central Station.
Your system may be programmed to send a “closing” report to your
security company when arming.
❒ My system sends a closing report.
❒ My system does not send a closing report.
Your system may be programmed to send an “opening” report to your
security company when disarming.
❒ My system sends an opening report.
❒ My system does not send an opening report.
Your system may be programmed to report Force Arming to your security
company.
❒ Force Arming will be reported to my security company.
❒ Force Arming will not be reported to my security company.
Your security system automatically disconnects your telephone from its
line when transmitting reports to your security company. This prevents
reports from being interrupted during transmission. Once the report has
been completed, the telephone line is restored to normal service.
Note: If damage occurs to the telephone line and your telephone service
is interrupted, reports will not be transmitted to your security company
unless an alternate means of transmitting signals is installed in your
system.
To Next Page
Loading...
