Bosch D9412GV2 - Figure 22: Connecting D8128 D Octopopits to the D7412 GV2

D9412GV2/D7412GV2 | Operation and Installation Guide | 9.0 Off-Board Points
50 Bosch Security Systems, Inc. | 7/09 | F01U003641-04
Figure 22: Connecting D8128D OctoPOPITs to the D7412GV2
Pin
Battery
amming
E CONNECTIONS
POWER +
DATA BUS A
DATA BUS B
COMMON
ZONEX OUT 1
ZONEX IN 1
32
31
30
29
28
27
NOT USED
26
25
NOT USED
NEX POWER +
24
COMMON 23
D5200/D5360
PROG CONN
1
2
1
2
1
2
1
2
1 - First address on Zonex Bus 1 2 - Sensor loops
Refer to Address Switches in Section 9.4.4 Setting the OctoPOPIT Switches on page 47 for
information about making these switch settings. Refer to Table 16 on page 47 for information
about setting Switch 5.
For system supervision, do not use looped wire terminals. Break the wire run to provide
supervision of the connections.