To Next PageTo Next Page
Need help?Do you have a question about the Bosch DS938Z and is the answer not in the manual?
General| Detection Range | 360° |
|---|---|
| Technology | PIR/Microwave |
| Walk Test | Yes |
| Power Supply | 10 - 15 V DC |
| Current Consumption | 12 mA at 12 VDC |
| Tamper Relay | Normally Closed (NC) |
| Operating Temperature | -10°C to +50°C |
| Humidity | 0 to 95% non-condensing |
| LED Indicator | Yes |
| Compliance | CE, UL, and FCC |
| Mounting Height | 8 ft to 12 ft (2.4 m to 3.7 m) |
| Alarm Relay | Form A, 28 VDC, 0.125A, Normally Closed |
| Alarm Output | Form A, 28 VDC, 0.125A, Normally Closed |
| Tamper Output | Form A, 28 VDC, 0.125A, Normally Closed |
Peel-off masks are provided with the unit for each segment of the optical module to allow for customized coverage, or to block out areas of objects that may cause thermal disturbances.
Adjust microwave range control to achieve maximum range. Minimum voltage change required for winter and summer.
Detector supervision features, including PIR self-test and motion monitor supervision. Indicates trouble conditions.
Connect VOM to Noise Voltage connector using TC6000. Measure background noise and target voltages for sensitivity.
Controls the Alarm/Test LED operation when activated by motion or for supervision trouble conditions.
Select sensitivity modes based on coverage type and installation environment for optimal intruder detection.
Select signal gain (High or Low) depending on the environment and coverage area for optimal performance.
