Cleaning and servicing en
11
Do not clean heavily soiled grease filters with
utensils.
Use special grease solvent for stubborn dirt. You
can obtain grease solvents from customer service
or the online shop.
3.
Start the dishwasher.
Select a temperature of no more than 70°C.
4.
Allow the grease filters to drain.
11.8 Fitting grease filters
ATTENTION!
Falling grease filters may damage the hob below.
▶ Grip below the grease filter with one hand.
1.
Using two hands, open the glass panel fully until the
glass support engages.
2.
Insert the grease filters.
3.
Fold the grease filters upwards and engage the
locks.
4.
Ensure that the locks engage.
5.
Using two hands, lift the glass panel slightly and
close it fully.
11.9 Odour filter for recirculating air mode
You can obtain odour filters from the after-sales service
or the online shop. Only use original odour filters.
→"Accessories", Page13
Replacing the odour filters
1.
Using two hands, open the glass panel fully until the
glass support engages.
2.
Position the front odour filter at the bottom and
swing it up .
The foam must be compressed when you insert it.
3.
Position the lower odour filter at the back and
swing it up .
The foam must be compressed when you insert it.
4.
Install the grease filters.
5.
Using two hands, lift the glass panel slightly and
close it fully.