en Installation instructions
18
9.
Insert the wall plugs flush with the wall.
Installing the appliance bracket
1.
Align the appliance bracket for the extractor hood
and screw it on hand-tight.
2.
Use a spirit level to align the appliance bracket hori-
zontally and screw it firmly in place.
Installing the appliance
1.
Remove the grease filters.
To avoid causing damage, do not bend the grease
filters.
2.
Attach the appliance.
3.
Screw the knurled nuts onto the safety screw by
hand and tighten them hand-tight.
4.
Position the front filter holder diagonally upwards
and insert it into the tabs. Push the lower filter
holder in so that it audibly engages.
5.
Insert the lower filter holder so that it audibly en-
gages.
6.
Insert the glass support in the opening and fold it
down as far as it will go.
7.
Align the glass panel at an angle of 90° to the ap-
pliance.
To Next Page
Loading...
