20 | English
1 609 92A 3MW | (21.11.16) Bosch Power Tools
The laser beam outlet 8 or
the reception lens 7 are
misted up (e.g. due to a
rapid temperature
change).
Wipe the laser beam out-
let 8 and/or the reception
lens 7 dry using a soft
cloth
The calculated auto-sum
is greater than 99999 m.
Divide calculation into in-
termediate steps
Measuring result not plausible
The target surface does
not reflect correctly (e.g.
water, glass).
Cover off the target sur-
face
The laser beam outlet 8 or
the reception lens 7 are
covered.
Make sure that the laser
beam outlet 8 or the re-
ception lens 7 are unob-
structed
Obstruction in path of la-
ser beam
Laser point must be com-
pletely on target surface.
The indication remains unchanged or the measur-
ing tool reacts unexpectedly after pressing a but-
ton
Software error Remove the batteries and
start the measuring tool
again after reinserting
them.
Cause Corrective Measure
OBJ_BUCH-3062-001.book Page 20 Monday, November 21, 2016 4:09 PM
To Next Page
Loading...
