Operating Instructions
Greentherm T9800 SEO 160/199 | SECO 199 – 6 720 817 281 (2018/12)
28
Fig. 27
To shut down the appliance:
▶ Press the button .
6.3 Error code reset
Some possible faults can be solved by resetting the appliance.
To remove an error code from the display,
▶ Press and hold button for more than 3sec.
The appliance will initiate the start up sequence.
NOTICE:
Appliance malfunction!
▶ If the problem persists, contact your installer.
6.4 Temperature selection
By default, the heating temperature of the water is 120 °F
(49 °C).
To select a hot water temperature:
▶ Press the buttons and until the desired
temperature is displayed.
Fig. 28
To increase setpoint temperature limit of the appliance:
▶ Access the menu LM - temperature Limit (
section 6.5.4).
A lower temperature set point will reduce the risk of scalding,
reduce energy consumption and increase the longevity of the
heat exchanger.
WARNING:
The temperature shown on the display is device measured,
always check with your hand before bathing children or elderly.
Fig. 29
6720806146-03.1V
6720806146-04.1V
To Next Page
Loading...
