-9-
Assembly
Blade Selection
No one blade can be efficient on all
cutting jobs. Different materials require
specially designed blades. Since your
reciprocating saw can cut so many
materials, many types of Bosch blades
are available. Be sure to use the proper
blade to ensure proper cutting
performance.
Installing and Removing
a Blade
Turn the blade change lever 4
approximately 60° in the direction
shown and hold it in place. Slide the
saw blade 1 into the saw blade holder
slot 3a. Let go of the lever 4 (Fig. 2).
Make sure the blade is securely locked
in place.
To remove the blade, turn the blade
change lever 4 approximately 60° in the
direction shown while pulling the blade
1 out of the blade slot. NOTE: be
careful, blade may be hot (Fig. 2).
Make sure that the
front end of the
blade extends through the footplate
for the entire stroke length. Do not use
specialty blades that are very short or
those with a significant cant. Blade must
not contact footplate. A blade which is
too short or tilted could jam inside the
foot and snap.
Inserting and Releasing
Battery Pack
Ensure the switch is
in the off position
before inserting battery pack. Inserting
the battery pack into power tools that
have the switch on invites accidents.
Slide charged battery pack 10 into the
housing until the battery pack locks into
position (Fig. 3).
Your tool is equipped with a secondary
locking latch to prevent the battery pack
from completely falling out of the tool
housing, should it become loose due to
vibration.
To remove the battery pack 10, press
the battery pack release button 10a and
slide the battery pack forward (Fig. 3).
Press the battery pack release button
10a again and slide the battery pack
completely out of tool housing (Fig. 3).
1
3a
4
FIG. 2
FIG. 3
10a
10
Disconnect battery pack from tool before making any assembly,
adjustments or changing accessories. Such preventive safety measures
reduce the risk of starting the tool accidentally.
To Next Page
Loading...
