English | 11
Bosch Power Tools 2 609 141 187 | (13.3.14)
Declaration of Conformity
We declare under our sole responsibility that the product de-
scribed under “Technical Data” is in conformity with the fol-
lowing standards or standardisation documents: EN 60745
according to the provisions of the directives 2009/125/EC
(Regulation 1194/2012), 2011/65/EU, 2004/108/EC,
2006/42/EC.
Technical file (2006/42/EC) at:
Robert Bosch GmbH, PT/ETM9,
D-70745 Leinfelden-Echterdingen
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
14.08.2013
Noise/Vibration Information
The measured values of the machine are listed in the table on
page 155.
Noise and vibrational values (vector sum of three directions)
determined according to EN 60745.
The vibration level given in this information sheet has been
measured in accordance with a standardised test given in
EN 60745 and may be used to compare one tool with anoth-
er. It may be used for a preliminary assessment of exposure.
The declared vibration emission level represents the main ap-
plications of the tool. However if the tool is used for different
applications, with different accessories or insertion tools or is
poorly maintained, the vibration emission may differ. This
may significantly increase the exposure level over the total
working period.
An estimation of the level of exposure to vibration should also
take into account the times when the tool is switched off or
when it is running but not actually doing the job. This may sig-
nificantly reduce the exposure level over the total working
period.
Identify additional safety measures to protect the operator
from the effects of vibration such as: maintain the tool and the
accessories, keep the hands warm, organisation of work pat-
terns.
Mounting and Operation
Battery GSR 14,4 V-EC
GSB 14,4 V-EC
GSR 18 V-EC
GSB 18 V-EC
Permitted ambient
temperature
– when charging
– during operation*
– during storage
°C
°C
°C
0...+45
–20...+50
–20...+60
0...+45
–20...+50
–20...+60
Recommended bat-
teries
GBA 14,4V
x,xAh M–.
GBA 18V
x,xAh M–.
* Limited performance at temperatures <0 °C
Henk Becker
Executive Vice President
Engineering
Helmut Heinzelmann
Head of Product Certification
PT/ETM9
Action Figure Page
Removing the battery
1 156
Inserting the battery
2 156
Mounting application tools
3 156
Reversing the rotational direction
4 157
Setting the torque
5 157
Selecting the drilling position
6 158
Setting the operating mode
7 158
Gear selection, mechanical
8 158
Mounting/dismounting the colour clip
9 159
Mounting/dismounting the bit holder
10 159
Switching On and Off
11 159
Selecting Accessories
– 160
OBJ_BUCH-2045-002.book Page 11 Thursday, March 13, 2014 7:55 AM
To Next Page
Loading...
