English | 19
Bosch Power Tools 2 609 932 590 | (26.6.07)
Temperature Dependent Overload Protection
When using as intended for, the power tool can-
not be subject to overload. When the load is too
high or the allowable battery temperature range
of 0–70 °C is exceeded, the speed is reduced.
The power tool will not run at full speed until
reaching the allowable battery temperature.
Protection Against Deep Discharging
The Li-ion battery is protected against deep dis-
charging by the “Electronic Cell Protection
(ECP)”. When the battery is empty, the machine
is switched off by means of a protective circuit:
The inserted tool no longer rotates.
Operating Instructions
f Apply the power tool to the screw only
when it is switched off. Rotating tool inserts
can slip off.
Soft Grip
The gripping surface (soft grip) 5 reduces the
danger of slipping and thereby improves the
grip on the machine and the handling.
At the same time, the rubber coating achieves a
vibration-reducing effect.
Craftsman Case (see figure D)
The craftsman case 13 can hold the power tool,
the respective battery charger, a spare battery
and additional accessories. The craftsman case
13 can be hung up with the utility clip 12.
Tips
For drilling in metal, use only perfectly sharp-
ened HSS drill bits (HSS=high-speed steel). The
appropriate quality is guaranteed by the Bosch
accessories program.
Before screwing larger, longer screws into hard
materials, it is advisable to predrill a pilot hole
with the core diameter of the thread to approx.
2
/
3
of the screw length.
Maintenance and Service
Maintenance and Cleaning
f Before any work on the machine (e. g.,
maintenance, tool change, etc.) as well as
during transport and storage, set the rota-
tional direction switch to the centre posi-
tion. Unintentional actuation of the On/Off
switch can lead to injuries.
f For safe and proper working, always keep
the machine and ventilation slots clean.
When the battery is no longer operative, please
refer to an authorised after-sales service agent
for Bosch power tools.
Always keep the tool holder 2 and the insert tool
clean to ensure the locking and releasing func-
tion of the locking sleeve3.
If the machine should fail despite the care taken
in manufacturing and testing procedures, repair
should be carried out by an after-sales service
centre for Bosch power tools.
In all correspondence and spare parts order,
please always include the 10-digit article
number given on the type plate of the machine.
After-sales service and customer assist-
ance
Our after-sales service responds to your ques-
tions concerning maintenance and repair of your
product as well as spare parts. Exploded views
and information on spare parts can also be
found under:
www.bosch-pt.com
Our customer consultants answer your ques-
tions concerning best buy, application and ad-
justment of products and accessories.
OBJ_BUCH-405-001.book Page 19 Tuesday, June 26, 2007 2:53 PM
To Next Page
Loading...
