English - 1
1 Thread for auxiliary handle (3x)
2 Spindle lock
3 On/Off switch
4 Auxiliary handle
5 Grinder spindle
6 Protective guard
7 Clamping screw
8 Coded projection
9 Mounting flange with O-ring
10 Roughing/cutting disc*
11 Clamping nut
12 quick clamping nut*
13 Adjustment screw
14 Clamping lever
15 Guard, grinding cup*
16 Grinding cup*
17 Hand protector*
18 Spacers*
19 Rubber sanding plate*
20 Sanding disc*
21 Round nut*
22 Cup brush*
23 Cutting guide with protective vacuuming
hood*
24 Diamond cutting disc*
25 Cutting grinder stand*
* Optional accessories
* Not all of the accessories illustrated or described are included as standard delivery.
The machine is intended for cutting, roughing and
brushing metal and stone materials without using
water. For cutting stone, a cutting guide is re-
quired.
Measured values determined according to
EN 50 144.
Typically the A-weighted noise levels of the prod-
uct are: sound pressure level: 90 dB (A); sound
power level: 103 dB (A).
Wear ear protection!
The typical weighted acceleration is 5.5 m/s
2
.
When using the auxiliary handle with vibration
absorption, the hand/arm vibration of the power
tool used is typically less than 2.5 m/s
2
.
Tool Specifications
Angle Grinder GWS 20-180 H GWS 20-230 H
Part number 0 601 849 0.. 0 601 850 0..
With residual current-limit control GWS 20-180 JH GWS 20-230 JH
Part number 0 601 849 9.. 0 601 850 9..
Rated power [W] 2 000 2 000
Output power [W] 1 250 1 250
No-load speed [rpm] 8 500 6 500
Grinding disk dia. max. [mm] 180 230
Grinder spindle threads M 14 M 14
Weight (without optional extras) approx. [kg] 4.2 4.2
Safety class / II / II
Please observe the order numbers of the machine. The trade names of the individual machines may vary.
Inrush currents cause short-time voltage drops. Under unfavourable power supply conditions, other equipment may be
affected. If the system impedance of the power supply is lower than 0.25 Ohm, disturbances are unlikely to occur.
Machine Elements
Intended Use Noise/Vibration Information
14 • 1 609 929 C69 • TMS • 21.08.01
To Next Page
Loading...
