20
1 609 929 820 • TMS • 14.02.00
■ Before any work on the machine itself, pull
the mains plug.
The machine head
can be rotated with
respect to the ma-
chine housing in 90°
steps. In this manner,
the on/off switch can
be brought to an ad-
vantageous handling
position for special
working situations,
e. g., for cutting work
with the cutting
guide 21/ cut-off
stand 18 (optional ex-
tra) or for left-handed
persons.
Unscrew completely the four screws.
Rotate the machine head carefully and without
removing from the housing to the new position.
Screw in the screws again and tighten.
■ Before any work on the machine itself, pull
the mains plug.
☞
For safe and proper working, always keep
the machine and the ventilation slots clean.
In extreme working conditions, conductive
dust can accumulate in the interior of the
machine when working with metal. The pro-
tective insulation of the machine can be de-
graded. The use of a stationary extraction
system is recommended in such cases as
well as frequently blowing out the ventila-
tion slots and installing a residual current
device (RCD).
If the machine should fail despite the rigorous
manufacturing and testing procedures, repair
should be carried out by an authorised after-saled
service centre for Bosch power tools.
In all correspondence and spare parts orders,
please always include the 10-digit order number
given on the nameplate of the machine.
WARNING! Important instructions for con-
necting a new 3-pin plug to the 2 wire cable.
The wires in the cable are coloured according to
the following code:
Do not
connect the blue or brown wire to the earth
terminal of the plug.
Important: If for any reason the plug is cut off the
cable of this machine, it must be disposed of
safely and not left unattended.
We guarantee Bosch appliances in accordance
with statutory/country-specific regulations (proof
of purchase by invoice or delivery note).
Damage attributable to normal wear and tear,
overload or improper handling will be excluded
from the guarantee.
In case of complaint please send the machine,
undismantled, to your dealer or the Bosch Serv-
ice Centre for electric power tools.
Measured values determined according to
EN 50 144.
The A-weighted noise levels of the machine are
typically: sound pressure level: 88 dB (A); sound
power level: 101 dB (A).
Wear ear protection!
The weighted acceleration is typically 5.0 m/s
2
.
Rotating the Machine Head
Maintenance and Cleaning
Guarantee
Noise/Vibration Information
strain relief
live = brown
neutral = blue
To be fitted
by qualified
professional only
To Next Page
Loading...
