-19-
Assembly
▶ Abrasive Type 27 Grinding
Wheel & Sanding Flap Disk
Assembly
Do not use accessories
that run eccentrically.
The tool will vibrate excessively and may
cause loss of control and the accessory
may burst.
To install grinding wheel or flap disk (Fig.
12) see instructions on page 17.
Fig. 12
Type 27
Wheel Guard
Type 27
Grinding
Wheel
▶ Abrasive Type 41/1A
Cutting Wheel Assembly
Always use type 41/1A
cutting guard for cut-
ting operations. Other guards or attach-
ments may not protect operator in the
event of a wheel burst.
To install cutting wheel (Fig. 13) see in-
structions on page 17.
Fig. 13
Type 41/1A
Wheel Guard
Type 27
Cutting Wheel
Type 41/1A
Cutting Wheel
To Next Page
Loading...
