Bosch HBG672B 1A Series - After Cleaning Function Completion; Rails; Detaching and Refitting Rails

Troubleshooting en
23
Fault Cause and troubleshooting
The time is not displayed when
the appliance is switched off.
Basic setting has been changed.
▶
Change the basic setting for the time display.
→"Basic settings", Page15
Appliance door cannot be
opened.
The cleaning function locks the appliance door; lights up in the display.
▶
Allow the appliance to cool down until goes out in the display.
→"Cleaning function Pyrolytic self-cleaning", Page17
The childproof lock locks the appliance door.
▶
Use the button to deactivate the childproof lock.
→"Childproof lock", Page14
You can switch off the lock in the basic settings.
→"Basic settings", Page15
The control ring has fallen out of
the mount in the control panel.
The control ring has been detached.
1.
Insert the control ring into the mount in the control panel.
2.
Push the control ring into the mount so that it clicks into place and can be
turned.
The control ring is difficult to turn. There is dirt below the control ring.
The control ring can be removed.
Note:To ensure that the mount remains stable, do not remove the control ring
too often.
1.
To loosen the control ring, press on the outer edge of the control ring.
a The control ring tilts and is easier to grip.
2.
Remove the control ring from the mount.
3.
Clean the control ring and its mount on the appliance carefully using soapy
water and a dish cloth. Dry with a soft cloth.
Do not use any harsh or abrasive cleaning agents.
Do not soak the control ring.
Do not clean the control ring in the dishwasher.
The interior lighting does not
work.
The halogen lamp is defective.
▶
Change the oven light bulb.
→"Replacing the oven light bulb", Page24
Maximum operating time
reached.
To prevent an unwanted permanent operation, the appliance automatically stops
heating after several hours if the settings are unchanged. A message appears in
the display.
The point at which the maximum operating time is reached is determined by the
corresponding settings for an operating mode.
1.
To continue the operation, press any touch field and turn the control ring.
2.
If you do not need to use the appliance, use to switch it off.
Tip:To prevent the appliance from switching off when you do not want it to, set
a cooking time.
→"Setting the cooking time", Page12
A message with "D" or "E" ap-
pears in the display, e.g. D0111
or E0111.
The electronics have detected a fault.
1.
Switch the appliance off and on again.
a If the fault was a one-off, the message disappears.
2.
If the message appears again, call the after-sales service. Please specify the
exact error message when calling.
→"Customer Service", Page24
The cooking result is not satis-
factory.
Settings were unsuitable.
Setting values, e.g. temperature or cooking time, depend on the recipe, quantity
and food.
▶
Next time, set lower or higher values.
Tip:A lot of information about the food preparation and corresponding set-
ting values can be found on our website www.bosch-home.com.