English 37
Warming Drawer Maintenance
Removing the Drawer
1. Pull drawer to fully open position.
2. Press down right drawer clip.
3. Lift up left drawer clip.
4. Firmly pull the drawer straight out. Retract cabinet rails
while drawer is removed.
Replacing the Drawer
1. Be sure housing slides are pushed inside housing.
2. Align the drawer rails with the housing slides attached
to the drawer housing.
3. Firmly push the drawer straight into the drawer housing
until the drawer clicks into place. Note: The drawer has
a “push-to-open” operation. Pressing the lower center
front of the drawer causes the drawer to self-open.
4. Open and close drawer to test operation. Note: if the
drawer will not close, verify that the rails on the drawer
are properly aligned to housing slides and that the rail
release levers are properly positioned.
9 CAUTION
To prevent burns, do not remove drawer while hot.
Be sure drawer is empty before removing.
Parts
1 Housing
2 Drawer
3 Housing slide
4 Drawer rail
/
2
:
+
,
*
+
B
0
(
'
3
5
2
2
)
2
1
2
)
)
To Next Page
Loading...
