length/slackhasbeenadjusted,attachstrainreliefperinstructionsincludedwith
strainrelief.
Tip:Theknockoutpanelbelowtheterminalblockcanberemovedfrom
therangetoinstallthestrainrelief:Removeknockoutpanelfromrange,
installstrainreliefinpanelandreattach.DONOTremoveentirerange
backpane.
!!l
Figure8: Strain Relief Knockout
,_Warning: Risk of Electric Shock or Fire. Frame grounded to neutral
through a ground strap. Grounding through the neutral conductor is prohibited
for new branch-circuit installations (1996 NEC), mobile homes, and recreational
vehicles, or in an area where local codes prohibit grounding through the neutral
conductor.
For installations where grounding through the neutral conductor is prohibited,
(a) disconnect the link from the neutral, (b) use grounding terminal or lead to
ground unit, (c) connect neutral terminal to lead branch circuit neutral in usual
manner (when the appliance is to be connected by means of a cord kit, use 4-
conductor cord for this purpose).
Use only cord kits rated 125/250 volts (minimum), 40 or 50 amperes (depend-
ing on local code) and labeled "For Use with Ranges". Strain relief provided
with cord must be installed per instructions
3-WIRE HOOK UP 4=WIRE HOOK UP
Figure 9: Grounding Requirements
,_Warning: To prevent electrical shock, the grounding prong on the range
cord should not be cut or removed under any circumstances. It must be plugged
into a matching grounding type receptacle and connected to a correctly polarized
240- Volt circuit. If there is any doubt as to whether the wall receptacle is properly
grounded, have it checked by a qualified electrician.
English 9
To Next Page
Loading...
