Bosch HES7252U-01 - Installation; Before You Begin

• Removealltapeandpackagingbeforeusingtheappliance.Destroythepack-
agingafterunpackingtheappliance.Neverallowchildrentoplaywithpackag-
ingmaterial.
• Nevermodifyoraltertheconstructionoftheappliance.Forexample,donot
removelevelinglegs,panels,wirecoversoranti-tipbrackets/screws.
• Toeliminatetheriskofburnsorfirebyreachingoverheatedsurfaceunits,
cabinetstoragespacelocatedabovethesurfaceunitsshouldbeavoided.If
cabinetstorageisto beprovided,theriskcanbereducedbyinstallingahood
thatprojectshorizontallya minimumof5inchesbeyondthebottomof the
cabinet.
• Verifythatcabinetsabovethecooktopareamaximumof13"(330mm)deep.
Installation
Before You Begin
Tools and Parts Needed
Additional Parts Needed For
Hard Wire Installations
Parts Included
40 or 50 Amp Power Supply Cord Kit (depending on local code)
Note: Not necessary for Canadian installations
Measuring Tape
Phillips Head Screwdriver
1-1/4" (31.8 mm) Wrench
Pencil
T-20 Torx Screwdriver
Screws (2) and Anchors (2) for Anti-Tip Bracket (Style will vary depending on
mounting surface)
Level
Drill and Drill Bit
Soapy Water
Safety Gloves and Goggles
Tape (Optional)
Cloth or Cardboard (Optional - to Protect Floor)
• Flexible Conduit
• Torque Wrench
• Note: Power Supply Cord Kit Not Necessary For Hard Wire Installations
• Anti-Tip Bracket
• Foam Tape
• Terminal Lugs (For Use With Hard Wire Installations) (not necessary for
Canadian installations)
English 2