Bosch HGI8046UC - 6 Before using for the first time; 6.1 Cleaning the appliance before using it for the first time; 6.2 Setting the clock; 6.3 Assembling the burner parts

Before using for the first time en-us
21
2. Tilt the front of the rack up about 3/4'' (2cm) and
finish pushing the rack all the way back ⁠.
Note:Avoid striking the oven light cover glass when
pushing the rack into position.
a The back of the telescopic rack drops in to place.
3. Pull the rack forward to engage the bottom of the rack
onto the rear of the rack position guide.
4. Lower the front of the rack to finish seating it on the rack
guide. The rack should feel stable when properly
seated.
5. Slide the movable part of the telescopic rack in and out
a few times to make sure it is able to move freely and
that the non-moving part of the telescopic rack is
securely anchored.
Before using for the first time
6 Before using for the first time
Before using for the first time
Carry out these steps before using your appliance.
¡ The appliance must be properly installed by a qualified
service provider before use.
¡ Read and understand all safety precautions → Page3
and information in the Use and Care Manual prior to
operating.
¡ This Use and Care Manual covers several models. Not
all features are available on all models.
6.1 Cleaning the appliance before using it for
the first time
Clean the oven cavity and accessories before using the
appliance to prepare food for the first time.
1. Remove all packaging materials from the oven cavity.
2. Keep the room ventilated while the appliance is heating.
3. Set the heating mode and temperature.
Heating mode Bake
Temperature 475°F (245°C)
Duration 30minutes
4. Switch off the appliance after the specified cooking
time.
5. Wait until the oven cavity has cooled down.
6. Clean the smooth surfaces with soapy water and a dish
cloth.
7. Clean the accessories using soapy water and a dish
cloth or soft brush.
Note:There may be a slight odor during first uses. This is
normal and will disappear.
6.2 Setting the clock
Requirement:The oven is in standby mode.
1. Press Settings.
a The display shows "SET CLOCK".
2. Press Enter.
3. Use the numeric keypad to enter the desired time.
The numbers fill in from right to left. To enter 10:45,
type 1, 0, 4, 5.
4. Press Enter.
6.3 Assembling the burner parts
1. Ensure that the burner parts are clean and dry.
2. Ensure that the individual parts of the burners are fitted
in their exact position and are straight; otherwise, this
may result in ignition problems or problems during
operation.
3. Fit the burner head and the burner ring in such a way
that the locking catches on the lower section of the
burner click into place in the corresponding recesses.
6.4 Flame characteristics
The color of the flame tells you if the gas supply is properly adjusted.
Note:Allow the appliance to operate for 4 to 5minutes before evaluating the flame. Some yellow streaking is normal
during the initial startup.