en Appliance door
18
3. Fold back both locking
levers (figure C). Close the oven door.
:Warning – Risk of injury!
If the oven door falls out accidentally or a hinge snaps
shut, do not reach into the hinge. Call the aftersales
service.
Removing and installing the door panels
To facilitate cleaning, you can remove the glass panels
from the oven door.
Removal
1. Detach the oven door and lay it on a cloth with the
handle facing down.
2. Pull off the cover at the top of the oven door. Press
in the tabs on the left and right using your fingers
(fig. A).
3. Lift the top panel up and pull it out (fig. B).
4. Lift the panel up and pull it out (fig. C).
Clean the panels with glass cleaner and a soft cloth.
:Warning – Risk of injury!
Scratched glass in the appliance door may develop into
a crack. Do not use a glass scraper, sharp or abrasive
cleaning aids or detergents.
Installation
During installation, make sure that the lettering "top
right" is upside down at the bottom left.
1. Insert the panel at an angle towards the back
(fig. A).
2. Insert the top panel at an angle towards the back
into the brackets. The smooth surface must face
outwards. (fig. B).
3. Put the cover back in
place and press on it.
4. Attach the oven door.
Do not use the oven again until the panels have been
correctly installed.
%
$
&
%$
&
%
$
To Next Page
Loading...
