Thedisplayflashes(no
power)whenyouplace
apanonaninduction
element
Thepanisnotferromagnetic
Thediameterofthepanistoosmall.
Checkthebottomofthepanwitha magnet.
Useapanwithanappropriatediameterfortheele-
ment.
Ifthedisplaystilldoesnotlightupwhenyouturn
theelementoffandonagain,disconnecttheappli-
anceatthecircuitbreaker.Wait20secondsand
thenreconnectit.
TheSpeedBoostfunc-
tiondisplayflashesand
thenturnesoff
TheSpeedBoostfunctionoperatestheelement
withthehighestpossiblepower.Duringlongcook-
ingtimes,itispossiblethatthefunctionwillturnthe
elementofftoprotectthecooktopfromoverheat-
ing.Youcancontinuetousethecooktopifthedis-
playisnotflashing.
DisplayE and numbers A fault in the electronic system has Turn the appliance off and back on at the fuse or
occurred, ciruit breaker. If the same fault occurs again, dis-
connect the appliance and call Technical Assis-
tance Service.
Display F and numbers A fault has been detected. The following table of error messages lists actions
you can take to correct the problem.
E
,- + number / o -- Electronic system malfunction. Unplug the cooktop from the mains. Wait about
number / B + number 30 seconds before plugging it in again.*
F_ r_
u / ,-3 There is an internal operating error. Unplug the cooktop from the mains. Wait about
30 seconds before plugging it in again.*
F2 The electronic system has overheated Wait until the electronic system has cooled down
and the corresponding burner has sufficiently. Then touch any symbol on the cooktop.
been turned off. *
The element is too hot.
F'4
F,-
3 + power level and There is a hot pan on the control Remove that pan. The malfunction indicator will
beep panel. It is highly likely that the elec- turn off shortly afterwards. You can carry on cook-
tronic system will overheat, ing.
F,-
3 and beep There is a hot pan on the control Remove that pan. Wait a few seconds. Touch any
panel. The burner has turned off to key on the control panel. When the malfunction
protect the electronic system, indicator turns off, you can carry on cooking.
II I
La , Incorrect supply voltage, outside nor- Contact your electricity distributor.
mal operating limits.
,_,:/,_,3 The burner has overheated and has Wait until the electronic system has cooled down
turned off in order to protect its cook- sufficiently before turning it back on.
ing surface.
* If the warning persists call the Technical Assistance Service.
Do not rest hot pans on the control panel.
The electronic system has overheated
and all burners have been turned off.
English 41
To Next Page
Loading...
