28 | English
Problem Possible Cause Corrective Action
Mower outside of
perimeter wire
Perimeter wire on a slope Leave 30 cm between the perimeter wire and the slope.
Obstacle near perimeter wire Remove obstacle.
Parts of the lawn area
left uncut
Mower requires more cuts to finish garden Allow mower to run for 3 full cuts to cover whole lawn
area.
Time slot not long enough for garden size
Increase mowing time slot or use "Bosch AUTO" Calen-
dar Function.
Distance between perimeter wires too
small
Increase distance between the perimeter wires to a min-
imum of 75 cm.
Rough mowing conditions Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Flatten garden/remove/bumps/mark out unsuitable
areas with the perimeter wire – Please follow the instruc-
tions in the Installation Guide.
Grass too long Select "uneven ground/low sensitivity" option from menu
item "lawn condition/bump sensor".
Slopes in garden too steep Ensure mower only operates on slopes of 15 degrees or
less and full garden is not on a slope.
Mower gets stuck in
garden
Objects/obstacles not marked out Use the perimeter wire to mark off obstacles where the
mower often gets stuck.
Newly laid turf Allow a few weeks for the soil to settle before using the
mower.
Change setting in menu item "lawn condition/bump
sensor".
After watering, wait as long as possible until you start the
mower.
Mower unintentionally
cuts flowers, etc. or
runs over certain
obstacles
Objects/obstacles below 5cm not marked
out
Mark obstacle using perimeter wire leaving 30cm from
object or remove objects/obstacles.
Mower does not ap-
pear to cut logically
LogiCut system depends on the garden
conditions (e.g. mower may go to the
closest unmowed area rather than to the
last mowed spot). Mower does not neces-
sarily have to continue in the next uncut
area.
Further information can be found on the Installation
Guide.
If behaviour re-occurs often, remap garden.
Mower does not always go in a straight line
when travelling between areas
No corrective action needed.
Mower frequently does not find right posi-
tion or turns on the spot
Change wire ID.
Wire crossed while marking an object Check that laid perimeter wire does not cross.
Follow instructions in the Installation Guide.
Mower runs in random paths in an addi-
tional lawn area without docking station.
Normal behavior. The LogiCut system only works in areas
with docking station.
Perimeter wire keeps
being cut
Wire is not taut between pegs
Distance between pegs is more than 75cm
Make wire taut and ensure distance between pegs is
maximum 75 cm. Follow instructions in the Installation
Guide. Use wire connectors to repair the disconnection.
Avoid using a verticutter, scarifier, etc. over the peri-
meter wire.
Mower leaves ragged
finish/poor quality of
cut
The mower does not mow often enough Mow more frequently for a good result (e.g. by means of
more/longer slots in schedule).
F 016 L81 848 | (01.10.2018) Bosch Power Tools
To Next Page
Loading...
