32 | English
F 016 L81 082 | (17.12.13) Bosch Power Tools
The blades do not rotate when the machine follows the wire
for the first time.
Note: Whilst mapping the Indego will follow the wire around
the edge of the lawn area. Where the wire is run to and from
an obstacle within 1 cm as described the Indego will not de-
tect the wire but continue along the wire around the perimeter
of the lawn. (see figure 7)
Mapping is complete when the machine reaches the back of
the docking station.
If the machine hasn’t reached the back of the docking station
press “Obstacle” and observe information indicated on the
screen to complete installation.
If the machine has reached the back of the docking station
press “Docking Station”.
Indego 1300
The screen will give an option to name the garden with one of
the preset names in memory. To then map another garden
place the Indego 1300 in the Docking Station in the additional
garden. The Indego will then allow you to map an additional
garden using the “Map Now” button.
After a successful installation you can either immediately be-
gin to mow by pressing “Mow now” or set up a mowing sched-
ule in the “Menu > Select Daily Timer”.
For more information about the behaviour of the machine
while mowing see section “Mowing”.
Setup of Mowing Schedule
Configure the mowing schedules and the settings of the ma-
chine according to your needs.
Approximate runtimes to complete a full garden coverage are
quoted below. Please note that the runtimes will vary depend-
ing on the lawn complexity and number of objects within the
lawn area.
All menu items are listed in section “Menu Navigation”.
The set up of a “Select Daily Timer” is explained in detail. The
other menus are self explaining.
Schedule
In “Menu > Select Daily Timer” 5 schedules are available.
“MANUAL” should be used if you only want to instruct the ma-
chine to operate at the current time.
Each of the “CUSTOM” mode can be scheduled according to
your needs.
Example:
Select a “CUSTOM” schedule with the up/down cursors, e. g.
“CUSTOM 1” and press “Edit”.
Select the mowing day with the up/down cursors, e. g. “Mon-
day” and press “Edit”.
Mapping Completed
Is this the back of the docking station
or an obstacle? If this is an obstacle,
remove it and machine will continue
mapping.
Obstacle
Docking
Station
Mapping Completed
Mapping Completed. Mower is re-
turning in the docking station.
Please wait.
Back
Robotic Lawnmower
Invented for life
Mow now Menu
200 m
2
2 h
500 m
2
6 h
800 m
2
9 h
1000 m
2
12 h
Select Daily Timer
View MANUAL
CUSTOM 1
CUSTOM 2
Edit CUSTOM 3
CUSTOM 4
CUSTOM 5
Back Select
CUSTOM 1
View Monday
Tuesday
Wednesday
Thursday
Friday
Saturday
Sunday
Edit
Back OK
OBJ_BUCH-1573-005.book Page 32 Tuesday, December 17, 2013 12:59 PM
To Next Page
Loading...
