Bosch Intuvia BUI255 - Displaying Data and Basic Settings; Viewing Trip and Speed Data; Accessing System Settings

English – 12
Switching the bike lights on and off has no effect on
the backlighting of the display.
Switching the push assistance on/off
The push assistance aids you when pushing your
eBike. The speed of this function depends on the se-
lected gear and can reach a maximum of 3.7mph.
u The push assistance function must only be used
when pushing the eBike. There is a risk of injury if
the wheels of the eBike are not in contact with the
ground while using the push assistance.
To activate the push assistance, briefly press the
WALK button on your on-board computer. After acti-
vation, press the + button within 10s and keep it
pressed. The eBike drive is switched on.
Note: The push assistance cannot be activated at as-
sistance level OFF.
The push assistance is switched off as soon as one of
the following occurs:
– You release the+button(12);
– the wheels of the eBike are locked (e.g. by applying
the brakes or hitting an obstacle);
– the speed exceeds 3.7mph.
The push assistance function is subject to local regu-
lations; the way it works may therefore differ from the
description above. It can also be deactivated.
Displays and settings of the on-board computer
Speed and distance indicators
The speedometer(f) always displays the current
speed.
You can choose from the following functions in the
function display (combination of text indicator(d)
and value indicator(e)):
– <Clock>: Current time
– <Max. speed>: Maximum speed achieved since
the last reset
– <Avg. speed>: Average speed achieved since the
last reset
– <Trip time>: Journey time since the last reset
– <Range>: Estimated range of the available battery
charge (at constant conditions such as assistance
level, route profile, etc.)
– <Odometer>: Total distance traveled with the
eBike (cannot be reset)
– <Trip distance>: Distance traveled since the last
reset
To switch between display functions, press
theibutton (1) on the on-board computer or
theibutton(10) on the operating unit repeatedly un-
til the required function is displayed.
To reset the <Trip distance>, <Trip time> and
<Avg. speed>, switch to one of these three functions
and then press and hold the RESET button (6) until
the indicator is set to zero. This will also reset the val-
ues of the other two functions.
To reset the <Max. speed>, switch to this function
and then press and hold the RESET button (6) until
the indicator is set to zero.
To reset the <Range>, switch to this function and
then press and hold the RESET button (6) until the in-
dicator is reset to the value of the factory setting.
If the on-board computer is removed from the holder
(4), all values of the functions are saved and can still
be displayed.
Displaying/adjusting basic settings
The basic settings can be displayed and changed re-
gardless of whether the on-board computer is in-
serted in the holder (4) or not. Some settings can
only be viewed and changed when the computer is in-
serted. Depending on the equipment of your eBike,
some menu items may not be present.
To go to the basic settings menu, simultaneously
press and hold the RESET button (6) and the i button
(1) until <Configuration> appears in the text indica-
tor (d).
To switch between the basic settings, press the i
button (1) on the on-board computer repeatedly until
the required basic setting is displayed. If the on-
1 270 U20 XBI | (14.03.2023) Bosch eBike Systems