EasyManua.ls Logo

Bosch KAN58A40AU - FAULT DIAGNOSTICS; Fault Display

Bosch KAN58A40AU
50 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
823_58300000113594_ara_en_u – 26.03.2015 Seite 39 von 50
7 FAULT DIAGNOSTICS
7.1 Fault display
The fault display is indicated after the test programme.
Fault
Component
Troubleshooting
Repair
F1
Freezer compartment sensor
Test the control module
Replace freezer compartment sensor
F3
Last defrost reset occurred
over time, not via the freezer
compartment sensor
Test the defrosting heater, thermal fuse
Replace defrosting heater, thermal fuse
r1
Refrigerator compartment
sensor
Test the control module
Replace refrigerator compartment sensor
rt = red
Ambient temperature sensor
Test the control module
Cannot be changed, replace complete control
electronics module
d1
Defrosting sensor
Test the control module
Replace defrosting sensor
dR
Refrigerator compartment
door switch
Open and close refrigerator compartment
door
Replace door switch
dF
Freezer compartment door
switch
Open and close freezer compartment door
Replace door switch
E1
Ice sensor
Test the ice maker
Replace ice maker
EF
Flow sensor
Test the inlet solenoid valve ?
Cannot be changed, replace complete solenoid valve
Et
Horizontal switch
Test the ice maker
Replace switch
Eu
On / Off switch
Test the ice maker
Replace switch
ES
Dispenser switch
Test the ice / water dispenser
Replace switch
Ea
Ice-maker motor
Test the ice maker
Replace motor
Eg
Inlet valve
Test the inlet valve
Replace inlet valve

Related product manuals