NL
m Warning
Note
The device is fully functional within the
indoor temperature limits of the indicated
climate class. When a device of climate
class SN is used at a lower indoor
temperature,
damage to the device is excluded up to a
temperature of +5 °C.
While changing
door suspension, the appliance must not be
connected to the mains. First pull the plug
from the socket. Place enough soft material
on the floor to avoid damaging the back of
the appliance. Carefully lay the device on its
back.
Note
Aeration
When the appliance is placed on its back,
the wall spacer must not be mounted.
Fig. $
The sky at the back of
the device heats up. The heated air must be
able to be discharged without hindrance.
Otherwise, the chiller has to perform more.
This increases energy consumption. The
The ventilation openings must therefore
never be covered!
watch the
ambient temperature
and the aeration
Ambient temperature
The device is designed for a specific climate
class. Depending on the climate class, the
device can be used at the following ambient
temperatures.
Connect device
After installing the device, you must wait at
least 1 hour before using the device.
During transport, the oil from the
compressor may enter the refrigeration
system.
The climate class can be
found on the type plate, fig. 4.
Climate class Permissible
ambient temperature
Before using the appliance for the first
time, clean the interior of the appliance (see
chapter „Cleaning
the device").
SN
N
ST
T
+ 10 °C to 32 °C
+ 16 °C to 32 °C
+ 16 °C to 38 °C
+ 16 °C to 43 °C
Electrical connection
The mains socket must be close to the
device and easily accessible even after
setting up the device.
84
To Next Page
Loading...
