en
9
Switching the
appliance on
Fig. "
Switch on the appliance with the On/Off
button 1.
A warning signal sounds. Temperature
display 2 is flashing.
Press the temperature setting button 4.
The warning signal switches off.
When the freezer compartment has
reached the set temperature, the
temperature display 2 is lit.
We recommend a factory setting of -18
°C in the freezer compartment.
Operating tips
■ When the appliance has been
switched on, it may take several hours
until the set temperatures have been
reached.
Do not put any food in the appliance
beforehand.
■ The sides of the housing are
sometimes heated slightly. This
prevents condensation in the area of
the door seal.
■ If the freezer compartment door
cannot be immediately re-opened after
it has been closed, wait until the
resulting low pressure has equalised.
Setting
the temperature
Refrigerator compartment
Turn temperature controller, Fig. !/10,
to the required setting.
We recommend a medium setting.
Changing the setting clockwise will lower
temperatures in the refrigerator
compartment.
Select a very cold setting only
temporarily if:
■ the ambient temperature is high,
■ door is opened frequently,
■ large quantities of food are placed in
the refrigerator compartment.
Freezer
The temperature can be set from -16 °C
to -26 °C.
Keep pressing temperature setting
button 4 until the required freezer
compartment temperature is set.
The value last selected is saved. The set
temperature is indicated on temperature
display 2.
Alarm functions
Fig. "
Door alarm
The door alarm (continuous sound)
switches on if the appliance door is open
for longer than one minute. Close
the door to switch off the warning signal.
To Next Page
Loading...
