Bosch Kiox 500 - Fitting; Testing the eBike Battery Before Using it for the First Time; Charging the eBike Battery; Battery charge indicator outside of the eBike

English – 3
Li-ion battery PowerPack
Frame 400
PowerPack
Frame 545
PowerPack
Frame 725
Operating temperature °C –5to+40 –5to+40 –5to+40
Storage temperature °C +10to+40 +10to+40 +10to+40
Permitted charging temperature
range
°C 0to+40 0to+40 0to+40
Weight, approx. kg 2.2 3.0 4.0
Protection rating IP55 IP55 IP55
Li-ion battery PowerPack Rack 400 PowerPack Rack 500
Product code BBP3340 BBP3350
Rated voltage V= 36 36
Nominal capacity Ah 10.8 13.6
Energy Wh 400 500
Operating temperature °C –5to+40 –5to+40
Storage temperature °C +10to+40 +10to+40
Permitted charging temperature
range
°C 0to+40 0to+40
Weight, approx. kg 2.7 2.8
Protection rating IP55 IP55
Fitting
u Ensure the eBike battery is placed on clean surfaces
only. Avoid getting dirt, e.g. sand or soil, in the charging
socket and contacts.
Testing the eBike Battery Before Using it for the
First Time
Test the eBike battery before charging it for the first time or
using it in your eBike.
To do this, press the on/off button (7) to switch the eBike
battery on. If none of the LEDs on the battery charge indic-
ator (6) lights up, the eBike battery may be damaged.
If at least one (but not all) of the LEDs on the battery charge
indicator (6) lights up, the eBike battery will need to be fully
charged before using it for the first time.
u Do not charge or use eBike batteries if they are dam-
aged. Contact an authorised bicycle dealer.
Charging the eBike Battery
u A Bosch eBike battery of the smart system generation
of systems must only be charged using an original
Bosch charger from the smart system generation of
systems.
Note: The eBike battery is supplied partially charged. To en-
sure full capacity of the eBike battery, fully charge the bat-
tery in the charger before using it for the first time.
To charge the eBike battery, read and follow the instructions
in the operating manual for the charger.
The eBike battery can be charged at any state of charge. In-
terrupting the charging process does not damage the eBike
battery.
The eBike battery has a temperature monitoring function
that only allows it to be charged within a temperature range
of 0°C to 40°C.
If the temperature of the
eBike battery is outside this
charging range, three of the
LEDs on the battery charge
indicator (6) will flash. Dis-
connect the eBike battery
from the charger and let it
reach the correct temperat-
ure range.
Do not reconnect the eBike battery to the charger until it has
reached the correct charging temperature.
Battery charge indicator outside of the eBike
The five LEDs on the battery charge indicator(6) indicate
the battery's state of charge when the eBike battery is
switched on.
Each LED represents approximately 20% of the charging ca-
pacity. When the eBike battery is fully charged, all five LEDs
will be lit.
The eBike battery's state of charge when switched on is also
shown on the display of the on-board computer. Read and
follow the instructions in the operating manuals for the drive
unit and on-board computer.
If the eBike battery's capacity is less than 10%, the last re-
maining LED will flash.
Bosch eBike Systems 0 275 007 3PX | (19.06.2023)