16
Operating the Dishwasher
NOTE: With hidden controls, the door must be opened before changing settings and
closed after changing settings.
Buttons are sensitive and should be touched gently. Avoid any grease or food parti-
cles resting on the buttons as they could activate the dishwasher. Wiping and clean-
ing can also activate the dishwasher. For best results, use bare, clean hands when
touching the buttons.
WARNING
To avoid risk of injury, always use caution when opening the door during or
following a wash cycle as hot water or steam may escape. Do not fully open
the door until water noises have stopped and steam has subsided.
Start the Dishwasher
1 Open the door and press the [On/Off] button.
2 Select a cycle and desired options and press [Start].
NOTE: You must press Start before closing the door.
Cancel a Cycle
1 Open the door and press and hold the [Start] button for approximately
3 seconds until the display reads “0:01”.
2 Wait about 1 minute while the dishwasher drains.
3 Open the door and press the [On/Off] button.
Interrupt a Cycle
1 Open the door and press the [On/Off] button to turn the unit off.
2 To resume the cycle, press the [On/Off] button again.
Delay Start
You can delay the start of the cycle in one hour increments up to 24 hours.
To set delay start:
1 Open the door and press the [On/Off] button. Select a cycle.
2 Press the [Delay] button until the displayed time corresponds with
your requirements and press [Start] to activate delay start.
h:01 = 1 hour delay h:24 = 24 hour delay
To cancel delay start:
1 Open the door and press the [Delay] button until “h:00” is indicated on the
digital display.
2 Press [Start] to save setting.
SHS63VLxUC*
C
B
A
* x can be any number
SanitizeDelicateDelay ExtraDry
ExtraScrub
Normal RinseHeavy Auto
Cycles
Options
To Next Page
Loading...
