18
InfoLight®
An LED illuminates the floor to indicate the unit is running. If the appliance is
installed at eye-level, the LED is not visible.
To change the setting:
1 Open the door and press the [On/Off] button.
2 Hold down the “A” button
(see page 17) and press [Start] until the dis-
play indicates “d:00”.
3 Release both buttons.
4 Press the “A” button until the display shows “1:01”.
5 Press the “C” button to switch between “1:01” = ON and “1:00” = OFF
and press [Start] to save. Close the door.
Aquastop® Leak Protection
Our AquaStop® system contains leaks through a precisely engineered tub
and sensor system that works with our solid molded base. If a leak has oc-
curred, it shuts down operation and automatically pumps out water to
avoid contact with the floor. It works 24/7 and can turn itself on.
To Next Page
Loading...
