Bosch Mastertech M-VCI - Step 2 - Connecting Your Wired Devices; Step 3 - Connecting Wireless Pcs

Robert Bosch LLC M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | April 2011
9 | Installation Steps | Step 3
Step 2 - Connecting Your
Wired Devices “Special
Instruction for Type II”
(Setting NETGEAR Router
Internet Port to the Cable/
DSL Modem)
Attaching the NETGEAR Router to
the cable/DSL modem.
Additional wired
devices
Wired connection
to PC (If required)
“Internet Port”
(Input from
the Cable/DSL
Modem)
You are now finished with Step 2,
proceed to Step 3.
Step 2 - Connecting Your
Wired Devices “Special
Instruction for Type III”
Connect wired computer(s) to the
router (if needed).
Additional wired
devices
Wired output
to PC(s)
Not used
Step 3 - Connecting
Wireless PC’s (if required)
“Special Instruction for
Types I, II & III”
f Open the Wireless Network
Manager for the PC that will
be interfacing with the new
NETGEAR Router.
f Search for wireless networks
– SSID = Bosch_VCI_AP
f Configure Encryption
– WPA Personal TKIP
– Passphrase = Bosch_
VCI_800-321-4889