Robert Bosch LLC M-VCI – NETGEAR® Router Installation Guide Index | Version 1.0 | April 2011
15 | Appendices
the NETGEAR router applicable
to your system configuration.
f Verify that you are using
the most current release of
Shop Foreman Pro and M-VCI
software.
f Verify firewall and security
settings on the computer
f Verify the Bosch Router
Wireless Network is set to the
– highest priority
– “Automatically” connect
f Verify all other wireless
networks are set to “Manually”
connect and lower priority
than the Bosch Router Wireless
Network
f Power-cycle the wireless
router and M-VCI
– This will force the router to
check for “open” channels
f Utilities such as NetStumbler
can assist in checking wireless
signal issues. NetStumbler
can be found at: http://www.
netstumbler.com/downloads/
Appendix C
Router Information
These are your NETGEAR Router
settings when finished with
installation:
Router IP address (after initial
configuration)
f Type I
– IP: 194.194.194.1
– Subnet Mask:
255.255.255.252
f Type II & III
– IP: 192.168.10.1
– Subnet Mask: 255.255.255.0
Router login information (after
initial configuration):
f User Name: admin
f Password: Bosch_VCI_AP
If necessary employ the following
to reset the router to factory
settings:
f With power applied to router,
hold down the Reset button
on the back of the unit for 30
seconds.
Appendix D
Using Multiple NETGEAR
routers.
It is possible to use multiple
NETGEAR routers together in
a single installation. In most
installations, a single NETGEAR
router is sufficient for handling
the communications between
To Next Page
Loading...