IP Camera 200 Series Installation | en 15
Bosch Security Systems Installation and Operation Manual AR18-09-B003 | v1.1 | 2010.05
3 Installation
3.1 Disassembly
The camera/housing unit consists of the following parts:
To disassemble the unit proceed as follows:
1. Using the special screwdriver bit supplied, loosen the two
tamper-resistant screws in the dome (the screws remain in
place).
2. Remove the dome from the base.
3. Remove the inner liner by pulling it off the base.
1. Dome
2. Inner liner
3. Camera module and mounting base
To Next Page
Loading...
