IP Camera 200 Series Installation | en 23
Bosch Security Systems Installation and Operation Manual AR18-09-B003 | v1.1 | 2010.05
Set the camera to the desired position by performing the
following steps:
1. For horizontal adjustment (pan), rotate the
camera module in the base. Do not rotate
more than 350°.
2. For vertical adjustment (tilt), loosen thumbscrews,
position camera, then gently tighten thumbscrews to
secure camera.
3. To obtain a horizontal horizon (for tilted ceilings or
sidewall mounting), rotate the base of the lens as
necessary to align the picture shown on the monitor. Do
not rotate more than 340°.
To Next Page
Loading...
